Boxerworks.com

Gidday,

many thanks to Jagarra cause I will soon have a few tiny spare parts heading Oz way in the post

Maybe by the time you need it someone will have taken one apart for exact sizes. What about taking apart the other side, it may have the same setup you could measure? ( in a plastic bag of course )

Gidday,

Jagarra - The parts arrived yesterday mate!! many thanks and I will have a go "carefully" at installing them later today.

Grant,

Good luck putting it back together. You know the original one will show up right after you get this spring installed.

gg

Gidday,

Jagarra I just fitted up the spring/ball combination to the switch and it now works a treat mate

I undone the switch, then I put a metal catch tray just underneath the working area, hung and tied that off so that it sat level just below the bars and then I draped a few towels over the bike and funnelled them down into the tray so that the ball would roll down into that each time it fell out while trying to install the ball, the spring would stay put but the ball would drop out and this time none went flying across the resto shed and never to be seen again

After about 30 minutes and a good few attempts I was successful and all is as it should be once again.

Thanks heaps for the spare parts and for posting them asap.

Grant,

I'm glad you were successful. Have a great Christmas.

regards,
gg